FLASH-CAN-48P-M26

The FLASH-CAN-48P is a low cost multifunctional evaluation board for 16-Bit Fujitsu Flash microcontrollers in a FPT-48P-M26 package.

It can be used stand alone for software development and testing or as a simple target board to work with the emulator system.

The board allows the designer immediately to start with the software development before his own final target system is available.

The target board will be delivered with the MB90F387 microcontroller. This microcontroller contains a 'burn-in'-boot loader for programming the flash.

Note: An optional power supply 9V-12V with center pin is GND (e.g.: PSU SNG12-24W) is required!

• Supports 16-Bit microcontroller in FPT-48P-M26 package (7x7x1.5mm, 0.5 mm pitch)
• MB90385 Series: MB90V495, MB90F387/S
• MB90455 Series: MB90V495, MB90F455/S, MB90F456/S, MB90F457/S
• MB90360 Series: MB90V340, MB90F362, MB90F367
• requires FLASH-CAN-48P-M26 V1.1 or newer
• MB90895 Series: MB90V495, MB90F897/S
• requires FLASH-CAN-48P-M26 V1.1 or newer
• 9-12V unregulated external DC power supply usable
• 5V internal power supply, Power-LED
• In-Circuit serial Flash programming
• All resources available for evaluation
• All pins routed to connectors
• 4 MHz main-crystal, 32kHz subclock-crystal (selectable by jumpers)
• One UART Interface
• One LIN-Transceiver
• One High-Speed CAN Transceiver
• 8 User LEDs
• optional: alphanumeric standard LC-Display connectable instead of LEDs
• Reset-Button, Reset-LED
• 5 User-buttons configurable for INT4, INT5, TIN0, IN0 and ADTG
• 64pin VG connector (same pin-out as Flash-CAN-64P-M09-V2)