Flash-CAN-100P-340

The FLASH-CAN-100P-340 is a multifunctional evaluation board for the Fujitsu 16-Bit Flash microcontroller 16LX MB90340, MB90800, MB90860, MB90945 and 16FX MB96340 Series. It can be used stand alone for software development and testing or as a simple target board to work with the emulator system. The board allows the designer immediately to start with the software development before his own final target system is available.

Note: An optional power supply 9V-12V with center pin is GND (e.g.: PSU SNG12-24W) is required!

• The following microcontrollers with M06/M22 package are supported:
• MB90340 Series: MB90F34xPF
• MB90800 Series: MB90F80xPF
• requires FLASH-CAN-100P-340 V1.1 or newer
• MB90860 Series: MB90F86xPF (MB90860series does not support CAN)
• MB90945 Series: MB90F94xPF
• requires FLASH-CAN-100P-340 V1.1 or newer
• MB96340 Series: MB96F34xPQC
• FLASH-CAN-100P-340 V2.0 or newer supports also 3.3V power supply
• 9-12V unregulated external DC power supply usable
• 5V internal power supply, Power-LED
• With version V2.0 or newer supports also 3.3V power supply is available
• In-Circuit serial Flash programming
• All resources available for evaluation
• All pins routed to connectors
• 4 MHz main-crystal, 32kHz subclock-crystal (selectable by jumpers)
• Two UART Interfaces
• Two LIN-Transceivers
• Two High-Speed CAN Transceivers
• 8 User LEDs
• optional: alphanumeric standard LC-Display connectable instead of LEDs
• Reset-Button, Reset-LED
• 5 User-buttons
• 96 pin VG connector