| This application note describes how to start development with the Fujitsu F2MC-8FX Family MB95200H/210H Series. |
mcu-an-500001-e-v11
|
| This application note describes how to start up the basic FW setting of the Fujitsu F2MC-8FX Family MB95200H/210H Series. |
mcu-an-500002-e-v11
Attachment
|
| This application note describes how to use IO Port. |
mcu-an-500003-e-v11
Attachment
|
| This application note describes how to use the 8/16-bit composite timer in various modes. |
mcu-an-500004-e-v11
Attachment
|
| This application note describes how to use 8/10-bit A/D converter in each mode. |
mcu-an-500005-e-v11
Attachment
|
| This application note describes how to use the LIN-UART in various modes. |
mcu-an-500006-e-v11
|
| This application note describes how to set and use the External Interrupt. |
mcu-an-500007-e-v11
Attachment
|
| This application note describes how to use the wild register function. |
mcu-an-500008-e-v11
Attachment
|
| This application note describes how to use DBG pin. |
mcu-an-500009-e-v10
Attachment
|
| This application note describes the Flash Security. |
mcu-an-500010-e-v11
Attachment
|
| The Application Note describes the function and operation of low-voltage detection reset circuit. |
mcu-an-500011-e-v11
|
| This application note describes the functions and operations of Clock Supervisor Counter. |
mcu-an-500012-e-v11
Attachment
|
| This application note describes how to use the watch-dog timer. |
mcu-an-500013-e-v11
Attachment
|
| This application note describes the main CR clock configuration and the CR trimming function. |
mcu-an-500014-e-v10
|
| This application note describes flash operation in MB95200H/210H Series. |
mcu-an-500015-e-v11
Attachment
|
| This application note provides some information and recommendations how to connect external crystals or resonators to Fujitsu microcontrollers. In order to achieve a proper and stable clock oscillation the composition of external circuits, PCB layout design and the microcontroller must be taken into account and evaluated carefully |
mcu-an-300007-e-v13
|
| This application note shows some possibilies to drive a BLDC motor with different MCUs using a single PPG. |
mcu-an-300020-e-v10
Attachment
|
| This application note describes how to use the Fujitsu’s LIN USART to control LIN devices (e.g.: AMIS-30621 stepper motor driver). |
mcu-an-300037-e-v11
Attachment
|
