| This is a short documentation to give an introduction how to start a project with the Softune Workbench. |
mcu-an-390025-e-v23
|
| This application note explains the different possibilities to program the Flash MCUs. |
mcu-an-390031-e-v26
|
| This application note describes the commands which are supported by the BiROM of the 16LX Flash MCUs in order to generate an own programming environment. |
mcu-an-390027-e-v28
|
| This application note roughly shows the necessary steps for transition to standby-mode and wake-up for 16LX Family MCUs. |
mcu-an-390058-e-v21
|
| How to set up a hardware environment for 16LX Family MCUs. |
mcu-an-390098-e-v20
|
| This appnote for the 16LX Family gives hints to optimize the EMI performance. |
mcu-an-390053-e-v14
|
| This application note gives a rough overview about the embedded A/D converter used within the 16LX Series and reflects the different modes that can be used. |
mcu-an-390084-e-v14
Attachment
|
| This installation guide will help you to quickly start setting up the MB2147-01 emulation hardware for Fujitsu 16-bit MCUs. |
mcu-an-390070-e-v29
|
| First steps how to use the Emulator MB2147-01 together with the Softune Workbench V30L28 or higher using an evaluation MCU with its Starter Kit. |
mcu-an-390069-e-v13
|
| This document describes the debugging methods of a MB90V340 system together with a FLASH-CAN-100P-340 target board. |
mcu-an-390083-e-v20
|
| Recommendation for MODE-Pins in case of external noise |
mcu-an-390093-e-v16
|
| This appnote shows how to use the dual operation Flash memory in the MB90F897. |
mcu-an-390091-e-v12
|
| How to implement an in-circuit EEPROM emulation with the dual-operation Flash in the MB90F897. |
mcu-an-390094-e-v12
Attachment
|
| This application note describes the most common SPI formats and how to implement them on Fujitsu 16-bit MCUs. |
mcu-an-300002-e-v12
|
| This application note provides some information and recommendations how to connect external crystals or resonators to Fujitsu microcontrollers. In order to achieve a proper and stable clock oscillation the composition of external circuits, PCB layout design and the microcontroller must be taken into account and evaluated carefully |
mcu-an-300007-e-v13
|
| This application note shows some possibilies to drive a BLDC motor with different MCUs using a single PPG. |
mcu-an-300020-e-v10
Attachment
|
| This application note describes the setup and using of a third party Flash programmer, CONITEC's GALEP-5 |
mcu-an-300022-e-v14
|
| This application note describes how to use the Fujitsu’s Softune with EasyCode |
mcu-an-300038-e-v10
|
| This Application Note describes how to setup the Softune Workbench to automatically start the debugger at start. |
mcu-an-300097-e-v11
|
